Norski Epoxy Carborundum

A highly filled Epoxy system for use as a hard wearing surface with good abrasion and long term RESISTANCE TO SEAWATER AND FRESH WATER immersion.

Used as a protective coating on the bottom of boats such as kayaks, jet boats and any boat which is run on to the beach. Can be applied to the sides of boats where gear is pulled aboard like cray pots.

Also makes an ideal nonskid surface on decks, stairways and any area that is wet and slippery.

Popular with jet boats a 750ml pack can cover the vee of the bow and for a patch 50mm wide either side of the centre line. Start 800mm below the water line and work up to approximately 250mm above the water line.

Colour white with flecks or black chips.

Being epoxy based clean up using Epoxy Thinners.

Part Numbers

750ml 26912,

1.5L 26913

Definitley a cold problem but you can get over it by taking the base (not the hardner and put it in the bucket of boiling water make sure the boiling water doesn't go over the top of the lid.

Application:

When mixed (2:1 ratio) it has the consistency of peanut butter thus is easier applied with a flat ended putty knife.

Simply mask generally 2’ either side of centre line, sand then apply in the desired thickness (generally 2-5mm)

Repeatedly dip your putty knife in water to alleviate the putty knife sticking too much to the mix.