Handrail Ends & Mids Forward or Backward 2 sizes avail

Stylish angled handrail Ends & Mids used for making rails, handrails and Toe-rails. An End for each end of your tube and the a mid supports the rail when span is too great, typically over 800mm you would start to add extra support mids.

Highly polished #316 grade Stainless Steel in two sizes to suit 25mm/1" or 22mm/ 7/8" Outside Diameter pipe.  (Pipe is measured in outside diameter whereas flexible hose is measured by internal diameter, handrail pipe is always rigid pipe and thus measured in outside diameter) 

Both sizes suit 2 x M5  countersunk machine screw fastening.

Some American runabouts, such as Bayliner, Campion, Sea Ray and similar use these fittings but in the cheaper zemac (alloy mix) suitable for fresh water boating. Our harsh salt water conditions necessitates the use of these stainless steel versions.

Backwards tends to be for against a windscreen and is unusual to be found on nz boats.

To make up an ordinary handrail  of say 1200mm you would use 2x forward facing ends (as in the main picture) and on mid.  The only time you would use a backward end is when the handrail ends at an angled windscreen and you wish to follow the windscreen angle.

Mid can be faced to the left or to the right as hole goes through centre so only needs forward version.