Stop Control Cable 11 sizes 2 styles

Diesel stop control cables / Choke cables / Fire extinguisher activation cables/heater flap controls.

Model #2 is a solid core centre and because of this will do pulling and pushing.  The one size that suits most, the 3.00m is adaptable in that it can be cut down on the job to shorten right down to .5m, simply by pulling out the inner, cutting the outer then putting the inner back in - only this size allows this as the outer is firmly crimped on the other sizes.

(19102X) - 1.3m

(19103AE) - 2.99m  (this size can be shortened right down to .5m by simply pulling out the inner and then cutting the outer to suit, then replace the inner and cut that inner to suit also. The other sizes listed are fixed to the specific length. )    

(19103) - 3.65m 

(19103N) - 5.48m        

(19103AB) - 6.5m     

(19103P) - 6.7m 

(19103Q) - 7.3m 

An integral tee handle (usually in black or red) is attached to the inner which consists of  a solid core stainless steel wire, (which allows pulling and pushing), so suitable for other uses and controls.

You can simply shorten the length of the inner cable by pulling the inner cable out and cutting to the correct length.

The tee handle is supported with a simple tube.

Also suits remote fire extinguisher control lines.

Allows a maximum of 75mm travel. Thread on the handle shaft allows for mounting in a bulkhead or panel.

Measurement is from the middle of the bulkhead where the handle is mounted to the end of the inner wire.